|
| I About Us I Products I Service & Calibration I References I Q & A I Contact us I |
เครื่องวัดก๊าซรั่ว (Gas Detector)--------- SPS Sensitron Park System |
|
SPS Sensitron Park System
Sensirtron Gas Detector for Carpark system and Tunnel
ได้ถูกออกแบบตามมาตรฐานสำหรับลานจอดรถหรืออุโมงค์รถยนต์ตามมาตรฐานยุโรปคุณภาพสูง ราคาประหยัด
THE EUROPEAN STANDARD EN 50545-1
In 2015, the European Union introduced a specific standard for the detection of toxic gases, namely CO and NO2, in car parks and tunnels.
CO thresholds will be set at 30 ppm as Alarm 1, 60 ppm as Alarm 2 and 150 ppm as Alarm 3
NO2 thresholds will be set at 3 ppm as Alarm 1, 6 ppm as Alarm 2 and 15 ppm as Alarm 3.
To reach this goal, it was decided to adopt time weighted averages (TWA) before triggering alarms. Thresholds 1 and 2 will trigger an alarm if the alarm condition is not restored in 15 minutes, while, for Alarm 3, ventilation will be triggered in a time interval between 1 to 5 minutes.
In the light of complying with the Standard, Sensitron designed a new innovative system combining the new MULTISCAN++ Park control panel and the SMART-P toxic gas detectors. The system guarantees the full compliance to this standard allowing time weighted alarm thresholds.
The specific software complies with EN 50271. |
 |
Sensitron Smart3 NC
Gas detectors series SMART3 NC have been designed to offer cost effective products with Hi-Tech professional features for car parks and non-classified areas.
Available for Methane, LPG, Petrol Vapours, CO, NO2 and CO2, these detectors employ a professional catalytic sensor for flammable gas detection, an electrochemical cell for CO and an infrared sensor for the CO2 detection.
The SMART3 NC provide an analog 4-20 mA output signal and can be implemented with additional features to allow the instrument to have an RS485 communication or three-relay output. IP55 |
 |
Sensitron Smart P
SMART P-1
Designed to fulfil the new European Standard for gas detection in car parks, the SMART P-1 gas detectors provide a serial RS485. The SMART P-1 employ electrochemical cells for the detection of CO or NO2. Certified to be in compliance with EN 50545-1 along with MULTISCAN++PK panels
SMART P-2
Designed to fulfil the new European Standard for gas detection in car parks, the SMART P-2 gas detectors offer the simultaneous detection of CO and NO2 or Petrol vapours integrated in the same detector.
EN 50545-1 along with MULTISCAN++PK panels |
 |
Sensitron Multi Scan ++ Park
The gas detection system for car parks SPS consists of MULTISCAN++Park control panels and SMART-P gas detectors, purposely designed to satisfy the European norm EN 50545-1.
The MULTISCAN++Park control panels can manage and monitor up to 256 gas detectors, but it can be customized |
 |
Sensitron Multi Scan ++ PK
MULTISCAN++PK gas control panel. 1 x RS485 type open bus line. 8 addressable gas detectors daisy chained to the RS485 control panel’s loops and 4 x 4-20 mA inputs on-board the panel. 5 relay outputs and additional 16 via remote STG/OUT16S card. The panel comes complete with 1 USB port for PC connection. Housed in plastic box for din-rail mounting |
|
Crowcon gas detector Crowcon gas detector Crowcon gas detector Crowcon gas detector Crowcon gas detector Crowcon gas detector Crowcon gas detector
GM GM GM GM GM honeywell honeywell Oldham Oldham Oldham Oldham Detronic Detronic Detronic Detronic Detronic Cosmos Cosmos Cosmos Cosmos Cosmos |
|
